Router Bit - Low Profile Flush Trim - D=19mm H=15.5mm L=62mm S=1/4"

TCT Router Bits
Each router bit features diamond ground, micro-grain tungsten carbide tipped blades. This tighter micro-grain structure means the blades offer long lasting hardness and superior edge retention. The body of each bit has been turned and then milled with uncompromising precision from a single piece of 4140 high tensile steel to give perfect balance for reduced vibration and therefore smoother cuts. 4140 steel has been chosen because of its toughness, high fatigue strength, and abrasion and impact resistance. The tungsten carbide tips are then brazed onto the bodies using induction to create an extremely strong joint that safely holds under the high stresses that occur when routing. The router bits are suitable for use on softwoods, hardwoods, veneers, laminates and composite materials.

Low Profile Flush Trim Bits
Low profile flush trim bits are used to trim overlaying edges of material such as laminates or veneers flush with the edge of a finished workpiece. These bits can also be used with a pre-cut template to copy and trim a workpiece to an existing profile. The low profile design allows the bit to be used in restrictive applications, on thin boards, where the long length of a standard trimming bit is not required. The two fluted cutting edges provide a clean and smooth final finish, leaving a neat edge on your workpiece. It is recommended that no more than 3mm of material is removed in one pass to reduce the risk of tearout.

Superior Finish and Performance
The shearing angle of the cutting edges ensure they remain in constant contact with the workpiece to allow a smoother, slicing cut which eliminates tear-out and gives a mirror finish. The bits feature right hook angles which further enhances the cut due to the fast removal of chips. These bits feature an anti-kickback design which limits the feed rate of the material being cut to decrease the likelihood of a kickback, meaning each bit conforms to strict German DIN standards to ensure maximum operator safety. ©