Brad Point Bit

Made from M2 high speed steel these brad point bits are the finest that we have ever offered. They feature two lips on the perimeter, that finely score the circumference of the hole, prior to the chipping bevels removing the stock. This results in minimal fibre pull and tearing of the wood leaving extremely clean holes in hardwoods, softwoods and composite woods.

The bits are back tapered from the cutting edge to minimise friction and prevent binding and have been fully ground to give precise concentricity to ensure a highly accurate hole. The deep flutes are polished to allow fast chip clearance, preventing the build up of swarf in the flutes, resulting in smooth scorch-free side walls. M2 high speed steel is extremely hard wearing and retains its hardness over prolonged use, resulting in a bit that will not deform and which will always keep the same cutting geometry over its lifetime. After hardening these bits are tempered to reduce brittleness and increase ductility and toughness, staying sharp 10 times longer than carbon steel brad point bits.

These bits are certified to ensure the dimensional accuracy of the hole and are available in 1mm increments from 3mm to 18mm. ©