Solid Carbide - Spiral Down Cut 2 Flute with 2 Bearings

Solid Carbide Router Bits
Each router bit has been precision ground from a single piece of super micro-grain solid tungsten carbide. This ultimate micro-grain carbide formulation gives the longest tool life and edge retention ensuring a very clean and accurate cut that leads to the ultimate finish. These STC router bits are suitable for use on softwoods, hardwoods, veneers, plastic materials, laminates, and composite materials.

Spiral Down Cut Two Flute Bits With Two Bearings
Spiral down cut two flute bits with two bearings are used for trimming and profiling, with the smaller diameters of the bits enabling them to cut into tight corner profiles. The two bearings give increased surface contact with the workpiece for greater stability during use. The down-cut design pushes chips down and away from the machine to eliminate splintering and tearout, and provide a finer top surface finish. These bits are ideal for veneered and laminated boards, providing a clean top edge.

Superior Finish and Performance
Each spiral has been specifically designed to give the optimum cutting angle to ensure the wood is sheared cleanly as well as providing efficient chip ejection. This leads to the bits running cooler during use as solid carbide dissipates heat more uniformly, even at high speeds, meaning the edges remain as sharp as possible and are retained for longer. Each bit conforms to strict German DIN standards to ensure maximum operator safety. ©